diamond MESFETs fabricated on hydrogenated polycrystalline diamond. The devices under examination have a coplanar layout with two gate fingers, total gate periphery of 100 lm; in DC they exhibit a hole accumulation behavior with threshold voltage Vt 0–0.5 V and maximum drain current density of 120 mA/mm. The best small-signal radio frequency performances (maximum cutoff or transition frequency fT and oscillation frequency fmax) were obtained close to the threshold and were of the order of 6 and 15 GHz, respectively. The power radio frequency response was characterized by driving the devices in class A at an operating frequency of 2 GHz and identifying through the active load-pull technique the optimum load for maximum power added efficiency. A power gain in linearity of 8 dB and an output power of approximately 0.2 W/mm with 22% power added efficiency were obtained on the optimum load impedance at a bias point VDS = 14 V, VGS = 1 V. To the best of our knowledge, these are the first large signal measurements ever reported for surface MESFET on polycrystalline diamond, and show the potential of such technology for the development of microwave power devices.
V., C., F., C., G., G., Rossi, M.C., P., C., Conte, G., et al. (2011). RF power performance evaluation of surface channel diamond MESFETs. SOLID-STATE ELECTRONICS, 55, 19-24 [10.1016/j.sse.2010.09.001].
RF power performance evaluation of surface channel diamond MESFETs
ROSSI, Maria Cristina
;CONTE, GennaroSupervision
;
2011-01-01
Abstract
diamond MESFETs fabricated on hydrogenated polycrystalline diamond. The devices under examination have a coplanar layout with two gate fingers, total gate periphery of 100 lm; in DC they exhibit a hole accumulation behavior with threshold voltage Vt 0–0.5 V and maximum drain current density of 120 mA/mm. The best small-signal radio frequency performances (maximum cutoff or transition frequency fT and oscillation frequency fmax) were obtained close to the threshold and were of the order of 6 and 15 GHz, respectively. The power radio frequency response was characterized by driving the devices in class A at an operating frequency of 2 GHz and identifying through the active load-pull technique the optimum load for maximum power added efficiency. A power gain in linearity of 8 dB and an output power of approximately 0.2 W/mm with 22% power added efficiency were obtained on the optimum load impedance at a bias point VDS = 14 V, VGS = 1 V. To the best of our knowledge, these are the first large signal measurements ever reported for surface MESFET on polycrystalline diamond, and show the potential of such technology for the development of microwave power devices.I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.
